Black Annealed Wire for packing

Products > Recycling Paper Baling > Black Annealed Wire for packing

Black Annealed Wire for packing

Black Annealed Wire

Hard Drawn Low Carbon Wire has been cold drawn to the required diameter and heat treatment is available. Often used for plating, redrawing and coating, it is important that the surface finish of the wire is clean and smooth. It will take moderate bending or flattening, machine ability is fair and the wire can be roll threaded.

This is a general purpose manufacturing wire suitable for a large range of applications. Various applications include super market trolleys, shelving, baskets, racks, hooks and general automotive parts.

Additional Info

Diameter Range: 1.60-12.50 mm

Diameter Range: 1.90-12.50 mm

Diameter Range: 4.00-7.80 mm

 

Hard Drawn Low Carbon Wire Specifications

Diameter Properties

Hard Drawn Low Carbon Wire is manufactured to comply with the following diameter tolerances:

Nominal Wire   Diameter

Tolerance (mm)

1.60mm up to   and incl. 1.80mm

over 1.80mm up to an incl. 2.80mm

over 2.80mm up   to and incl. 5.00mm

over 5.00mm up to and incl. 8.00mm

+/- 0.02

+/- 0.03

+/- 0.03

+/- 0.03

 

Tensile Strength (MPa)

The tensile strength is defined as the maximum load achieved in the tensile test, divided by the cross-sectional area of the wire test. The tensile strength developed depends on the amount of reduction in area to the finished size. Tensile is not considered of prime importance to this product however the following table is given as a general guide:

Nominal Wire   Diameter

Tensile Range   (Mpa)

less than or   equal to 1.75mm

over 1.75mm up to and incl. 2.00mm

over 2.00mm up   to and incl. 2.24mm

over 2.24mm up to and incl. 2.70mm

over 2.70mm up   to and incl. 2.80mm

over 2.80mm up to and incl. 4.20mm

over 4.20mm up   to and incl. 10.00mm

over 10.00mm up to and incl. 11.50mm

over 11.50mm   up to and incl. 12.50mm

800/1100

750/1050

700/1000

650/950

600/900

550/850

500/800

450/750

500/800

Steel Chemistry

OneSteel uses a variety of steel grades to manufacture its Hard Drawn Low Carbon range. The table below is indicative only of steel chemistries used.

-

HDLC

Truform

Hiform

% Carbon

% Phosphorus

% Manganese

% Silicon

% Sulphur

0.04 - 0.07

0.03 max

0.40 - 0.60

0.12 - 0.22

0.03 max

0.05 max

0.03 max

0.50 max

0.12 - 0.18

0.03 max

0.06 max

0.04 max

0.25 - 0.50

0.05 max

0.04 max


Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit