Electro Galvanized Iron Wire for Wire Mesh
Electro Galvanized Iron Wire for Wire Mesh
The metallic zinc coatings applied by the galvanizing process are an effective way of combating corrosion in steel.
Additional Info
Diameter Range: 0.2-5.00 mm
Surface Finish: Electro Galvanizing
Galvanised Wire Working Specifications
Given that galvanized wire is classified according to the amount of zinc coating, the following table outlines the difference between tensile strength.
Nominal Diameter | Minimum Coating Mass (g/m2) |
over 0.6mm up to and incl. 0.65mm over 0.75mm up to and incl. 0.85mm over 0.85mm up to and incl. 0.95mm over 0.95mm up to and incl. 1.06mm over 1.06mm up to and incl. 1.18mm over 1.18mm up to and incl. 1.32mm over 1.32mm up to and incl. 1.55mm over 1.55mm up to and incl. 1.80mm over 1.80mm up to and incl. 2.24mm over 2.24mm up to and incl. 2.72mm over 2.72mm up to and incl. 3.15mm over 3.15mm up to and incl. 3.55mm over 3.55mm up to and incl. 4.25mm over 4.25mm up to and incl. 5.00mm | 25 25 25 25 25 30 30 30 30 35 35 45 50 50 |
Diameter Properties
Standard Galvanized Wire is manufactured to comply with the following diameter tolerances:
Nominal Wire Diameter | Tolerance (mm) |
over 0.80mm up to and incl. 1.60mm over 1.60mm up to and incl. 2.50mm over 2.50mm up to and incl. 4.00mm over 4.00mm up to and incl. 6.00mm over 6.00mm up to and incl. 10.00mm | +/-0.03 +/-0.03 +/-0.03 +/-0.03 +/-0.03 |
Tensile Strength (Mpa)
The tensile strength is defined as the maximum load achieved in the tensile test, divided by the cross-sectional area of the wire test piece. Galvanized Wire is produced using soft, medium and hard grade wires. The following table specifies the tensile range according to the grade:
Grade | Tensile Strength (Mpa) |
Galvanised - Soft Quality Galvanised - Medium Quality Galvanised - Hard Quality | 380/550 500/625 625/850 |
Please note that the sizes mentioned above are indicative only and do not specify the size range available from my products range.
Steel Chemistry
A combination of steel grades is used and heat treatment processes to manufacture soft, medium and hard tensile grades. The table below is indicative only of steel chemistries used.
Tensile Grade | % Carbon | % Phosphorus | % Manganese | % Silicon | % Sulphur |
Soft Medium Hard | 0.05 max 0.15-0.19 0.04-0.07 | 0.03 max 0.03 max 0.03 max | 0.05 max 0.70-0.90 0.40-0.60 | 0.12-0.18 0.14-0.24 0.12-0.22 | 0.03 max 0.03 max 0.03 max |
- Name
- Phone
- Corporate name
- Address
- Leaving Message*
